2.11.2 The “Create Chamfer - For part corner” tool in Tekla Structures
This tool is applicable only for steel plates and poly beam objects and
is not creating a new object type such as chamfer. It just applies the
properties set of a chamfer in a point to a group of points.
Tekla Structures v21.1
Tekla Structures v2021
Create a plate with dimensions of 200x200. Select one of its points
Configure the values of parameters as it is shown in the below picture
Tekla Structures v21.1
Tekla Structures v2021
The algorithm for using the “Create Chamfer - For part corner”
Make sure all operations are canceled or press the Esc key.
Select the initial object (plate).
Enable the “Create chamfer- For part corner” tool.
Select the point subject for applying the properties of the formerly created
chamfer.
If required, select other points.
To disable the “Create chamfer- For part corner” tool, press
the Esc key.
Tekla Structures v21.1
Tekla Structures v2021
Since creating chamfers is available by configuring the parameters of
the “Chamfer properties” dialog window, we would not recommend
you to use the “Create chamfer- For part corner” tool.
This tool is applicable only for steel plates and poly beam objects and
is not creating a new object type such as chamfer. It just applies the
properties set of a chamfer in a point to a group of points.
Tekla Structures v21.1
Tekla Structures v2021
Create a plate with dimensions of 200x200. Select one of its points
Configure the values of parameters as it is shown in the below picture
Tekla Structures v21.1
Tekla Structures v2021
The algorithm for using the “Create Chamfer - For part corner”
Make sure all operations are canceled or press the Esc key.
Select the initial object (plate).
Enable the “Create chamfer- For part corner” tool.
Select the point subject for applying the properties of the formerly created
chamfer.
If required, select other points.
To disable the “Create chamfer- For part corner” tool, press
the Esc key.
Tekla Structures v21.1
Tekla Structures v2021
Since creating chamfers is available by configuring the parameters of
the “Chamfer properties” dialog window, we would not recommend
you to use the “Create chamfer- For part corner” tool.